This is version 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 . It is not the current version, and thus it cannot be edited.

Back to current version Restore this version

Introduction#

The DefaultMarkup is a markup template allowing to create new markups at low implementation workload. Further, the use of this template asserts a consistent structure of all markups leading to a unified look and feel of the system, considering syntax, rendering, and editing support.

This page describes the DefaultMarkup in general. An instructional page describing how to actually create a new markup based on the DefaultMarkup can be found here: HowTo-Create-Markup

Syntactical Structure#

A DefaultMarkup section always is introduced by two percent-signs (~)followed by the specific keyword of the markup.

Multi-line markup#

A DefaultMarkup section as multiple lines is terminated by another percent-sign (%).

%%<keyword> 
<content>
%

Single line markup#

DefaultMarkup blocks can also be defined in a single line. Then no trailing sign is required and the block is terminated by the line-break.

%%<keyword> <content>

Annotations#

Additionally to the content, also markup specific parameters can be specified. An annotation parameter is always state at the end of the markup block and is introduced by '@'.

A DefaultMarkup section as multiple lines is terminated by another percent-sign (%).

%%<keyword> 
<content>
@<annotation-name>: <value>
%

Single line markup#

DefaultMarkup blocks can also be defined in a single line. Then no trailing sign is required and the block is terminated by the line-break.

%%<keyword> <content> @<annotation-name>: <value>